Kubota L5

Agricultural tractor.

Die Radnaben an der Vorderachse können brechen, dies kann zu unsicheren Fahrzuständen oder dem Verlust eines Vorderrades führen.

Die Radnaben an der Vorderachse können brechen, dies kann zu unsicheren Fahrzuständen oder dem Verlust eines Vorderrades führen.

Die Radnaben an der Vorderachse können brechen, dies kann zu unsicheren Fahrzuständen oder dem Verlust eines Vorderrades führen.

Slow hydraulic oil leak from the spit pin (drain valve port) underneath the tractor, discovered immediately after hydraulic system service. Oil beads continuously from the pin, likely a seal issue introduced during maintenance.

I bought a new Kubota L5460. The very first time it required "regeneration" we followed the instructions in the manual, these are very poor instructions, and it would not regenerate after running over an hour. Next day tried the regeneration process going step by step by the manual. Again no regeneration. Contacted the dealer and they had to reprogram the computer to get the regeneration to work.

I am trying to comment on the gentleman above L5740. I had a B2920 and while using the bucket one day, the loader stopped the "dump" function. All other controls worked. I didn't think much of it as it was fairly new and under warranty. I forget now but it probably had 150 hours on it. The dealer was great and had it repaired in about THREE weeks. After a couple weeks they gave me an older unit so

So I have this Kubota L5030 from 2004. 3000 hrs on it. Bought it last summer as a light duty tillage tractor. Trying not to beat on it too badly and I’ve already replaced the 4 wheel drive axel seal but I had my mechanic do it. Noticed it was leaking oil last fall but I didn’t do much about it and parked for the winter. Came today to check out how bad it is and noticed the bottom of the axel housing had a loose ‘cap’? I cleaned it up and banged it back in but I feel there it most likely more to fix and replace. There’s probably other seals that need replacing too. I’m pretty good with mechanic work and would like to try and break it apart and do it myself. How difficult would this be? Any resources are gladly welcome.

I just got this Kubota L5030 this year and been using it a little bit. I noticed that there’s oil leaking from under the tractor at the front near where the axel attaches. How bad of a fix is this? Is it the seal?